Part 1| How to configure Intervlan Routing and IP Routing on Multilayer L3 Switch | on Packet Trace смотреть онлайн

Today I am gonna show you how to configure Multilayer L3 switch for Intervlan Routing by using Ip Routing configuration. Multilayer switch provide Protocol Data unit and Routing Function, also configure routing protocol in Multilayer L3 Switch.
Multilayer switches can perform Layer 2 and Layer 3 functions, replacing the need for dedicated routers.
Multilayer switches support dynamic routing and inter-VLAN routing.
The multilayer switch must have IP routing enabled.
A switch virtual interface (SVI) exists for VLAN 1 by default. On a multilayer switch, a logical (layer 3) interface can be configured for any VLAN.
The switch understands network-layer PDUs; (Protocol Data Unit) therefore, can route between its SVIs, just as a router routes between its interfaces.
With a multilayer switch, traffic is routed internal to the switch devices
Subscribe my channel Network Trainer for more network simulator and network training Tutorial.

More about CCNA tutorials
https://bit.ly/2A3Ec2c

For More Information about networking
https://bit.ly/36wOaoT

My whole Playlist
Essential of CCNA Routing & Switching | Networking Introducaiton Playlist
https://bit.ly/2zhpGUF

Introduction of Networking Explain Single and Collision Domain System CCNA
https://www.youtube.com/watch?v=xR1c2-t0QQc&t=97s

Introducation of CCNA
https://www.youtube.com/watch?v=21WhNtm15wI&t=17s

Introducation of Packet Tracer
https://www.youtube.com/watch?v=ptZLWHOUpRE&t=1s

Cisco Devices Startup User and Privilege Mode
https://www.youtube.com/watch?v=vHj8XrN751Y&t=39s

Telnet configuration
https://www.youtube.com/watch?v=dKUbJfYxFtI

Routing Protocol OSPF
https://www.youtube.com/watch?v=V-Pew5URUf8&t=2s

Routing Protocol EIGRP
https://www.youtube.com/watch?v=WD8sSk94E4c&t=1s

#ccna
#intervlan
#multilayer_switch